PPPoE connecting not dailing
-
I have been running PfSense (2.5.2) on my Hyper-V 2019 Host. This is working fine.
My internet is a fiber PPPoE connection (vLAN6). With a /29 subnet (IPv4).I would like to switch to ESX. So i setup the ESX (only 2 NICs) and installed a clean PfSense. I copied all the settings, Assignment screen, PPP/vLAN screen.
But for some reason the PPPoE will not connect. When i manually dial, it almost immediately jumps to disconnected.
So i think i have forgotten to copy a not so obvious PPPoE / network setting.
Any ideas?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginPrivacy Policy · Cookie Policy