Re: RC2e and embedded
rsw686 last edited by
You have to configure it first. Select the interface that it will run on in the settings.
If F screwed up your install you may want to figure out what the problem is because you will get bit later by RC3.
Please start a new thread with your RC2F issues.
Does RC2F work with the embedded as well and are the instructions for install the same. I didn't see it listed in the thread with the RC2 a,b,c,d,e instructions.
sullrich last edited by
Yes. However you RC2e is the latest atm.
pcatiprodotnet last edited by
The latest embedded fails to flash for me (tried re-download and re-flash several times), but older versions flash ok.
"Write error after 6365184 bytes (1196)."
hoba last edited by
Use the official RC2 embedded image from the mirrors and run the update scripts.