Error: PFSense cannot continue without at least one network interface card

[stephenw10]

What NICs does it have?

[brunorocha__]

@stephenw10 04 ports I226-V.

[stephenw10]

Like rev4 or it has 4 NICs?

[root@test4.stevew.lan]/dev: pciconf -lvc igc0
igc0@pci0:25:0:0:       class=0x020000 rev=0x04 hdr=0x00 vendor=0x8086 device=0x125c subvendor=0x8086 subdevice=0x0000
    vendor     = 'Intel Corporation'
    device     = 'Ethernet Controller I226-V'
    class      = network
    subclass   = ethernet
    cap 01[40] = powerspec 3  supports D0 D3  current D0
    cap 05[50] = MSI supports 1 message, 64 bit, vector masks 
    cap 11[70] = MSI-X supports 5 messages, enabled
                 Table in map 0x1c[0x0], PBA in map 0x1c[0x2000]
    cap 10[a0] = PCI-Express 2 endpoint max data 256(512) FLR RO NS
                 max read 512
                 link x1(x1) speed 5.0(5.0) ASPM L1(L1)
    ecap 0001[100] = AER 2 0 fatal 0 non-fatal 0 corrected
    ecap 0003[140] = Serial 1 0008a2ffff12ecd4
    ecap 0018[1c0] = LTR 1
    ecap 001f[1f0] = Precision Time Measurement 1
    ecap 001e[1e0] = L1 PM Substates 1

[brunorocha__]

@stephenw10
I can't enter any command, because PFSENSE hangs on the same screen as the first question in this post. Is there another way I can extract this information?

[stephenw10]

I would try to boot something else to confirm. Something Linux based is most likely to function.

You could boot a FreeBSD 14 snapshot, that will allow you install even if it doesn't find any NICs.
https://download.freebsd.org/ftp/snapshots/ISO-IMAGES/14.0/

[brunorocha__]

@stephenw10

Hello!
I was able to boot PFSense (version 2.6) with a USB/LAN interface. I updated to version 2.7 and now it recognizes the I226-V ports!

Thank you very much for all your attention!

[stephenw10]

Nice!

That's odd though. The 2.7 installer did not find that NICs directly?
There should be no difference between and upgrade from 2.6 or a clean 2.7 install. Certainly the kernel and drivers are the same.

Steve

[brunorocha__]

@stephenw10
I also found it very strange, because I installed version 2.7 before and it didn't recognize it. But this morning I tried to install the 2.6 version, use the USB interface and perform the update and this way it worked. Maybe it's something about the motherboard. Can I create a new topic about this case and point out this alternative?

[stephenw10]

It seems more like a bug if that's repeatable. Though it could be something specific to that board. It's hard to see how it would be any different.

[brunorocha__]

@stephenw10
I believe it could be yes. But resolved on my part. Thanks again for all the help!