Setting up gateway monitors ... Segmentation fault

IT170871 · May 29, 2023, 1:44 AM

Im running my SG-3100 with a multi WAN configuration and a failover from WAN1 to WAN2 as soon as WAN1 is down. It worked perfectly fine. After upgrading to 23.05 it bricked my device. It neither connected me to the internet nor let it me login to the GUI.

After connecting my notebook to the console I found this in the startup procedure.

Setting up gateway monitors...route: route has not been found
Segmentation fault (core dumped)

After disabling the monitoring for both gateways and a reboot, it worked again. As soon as I enable the monitoring for one of my two gateways, the issue comes back again doesn't matter what IP I am using for the monitoring.

jimp · May 30, 2023, 2:43 PM

That would seem to suggest a problem with the monitoring daemon files themselves. You might try running a manual filesystem check on the disk to ensure the filesystem is OK.

Might also be worth doing a reinstall (wipe and reload) of 23.05 to ensure everything is in a good and consistent state. You can request the install image from TAC.