ATT 2G fiber - upload is low
-
@akhouston said in ATT 2G fiber - upload is low:
I have pfsense+ 23.05 installed on a box wtih intel i225 - so 4 2.5Gb ports.
Is PPPoE in the "game play" you will be nailed to one queue
at the WAN, if not you can use more queues, one CPU core
= one queue.
On top the same role with the LAN ports too. As an example:
Intel i211at are only using 2 queues and Intel i210at is
able to use 4 queues. -
@stephenw10 Thanks, I don't think it made a difference.
-
@Dobby_ I am not sure pppoe is applicable to att fiber, but I am not sure either I understand your statement.
the box is basically celeron n5105 with i226 NIC and 32GB memory. -
Your WAN is DHCP you can see the gateway name so it's not that.
Check the CPU usage when you're testing. The best way to do that is to run
top -HaSPat the command line. -
@stephenw10 Actually this change cut down my download speed from about 1.4-1.5Gb to 600-700Mb. Removed it and the down speed is back to 1.4-1.5
-
@stephenw10 do i just take a snap of that in the Command Line window when running a test? I am watching the cpu usage chart on the dashboard and at the peak up and down test (those blue and orange charts onthe right, it didn't go higher than 30%, hence load average
-
So I ran iperf just to make sure nothing silly is going on. And it appears that pfSense sending is definitely heavier than pfSense receiving... Not sure where to dig from here, any ideas will be appreciated...
-
You set that rate limit to 20000 not 2000?
I'm surprised doing that could possibly reduce throughput.Yes, run top at the CLI then hit Q to quit leaving the data fixed to copy/paste out of there. Make sure you're not getting hung up on one core at 100%.
Steve
-
@stephenw10 I found the culprit, evidently the traffic shaper on the interface had a bandwidth limit of 1gbps - don't remember if and when I even set that, but whatever. Reset it and now i'm happy like a clam... Thanks everyone for your help.
-
Ha, that would do it. Nice.
