After 2.7.0 is released - Why do i see different Update -> Branch selections ?

[bingo600]

I have 5+ pfSense 2.6.0 CE installs, all running well.
Now that 2.7.0 has been released, i'd like to wait a bit before installing.
In order to not FSCK up package(s), i'm setting the Firmware Branch to - Previous stable.

Expected selections:
My main prod box - "Previous" 2.6.0 now selected.

On that box i have these selections in the "selection box"

Unexpected selections
My Test box

On that box i have these selections in the "selection box"

No 2.6.0 possible ... But 2.5.2 ????

What could have happened here ??

I think that all my boxes were "Clean" 2.6.0 installs, as in not upgraded from 2.5.2.
As i wanted to match the new 2.6.0 ZFS disk layout.

/Bingo

[jdeloach]

@bingo600 said in After 2.7.0 is released - Why do i see different Update -> Branch selections ?:

Unexpected selections
My Test box

On that box i have these selections in the "selection box"

No 2.6.0 possible ... But 2.5.2 ????

I'm seeing the same results as your Test Box on mine this morning. It wasn't that way
yesterday afternoon when 2.7.0 was released.

Something changed overnight on the Update site. This concerns me as whether I
want to risk updating or just stay with 2.6.0. I had planned on doing a clean
install of 2.7.0 CE and just import my 2.6.0 config but now not sure which way to go.

[bingo600]

Well i succeded in getting the "unexpected boxes" to show the "expected".

I had to switch to the "Devel" branch , then go to the pfSense main screen , it will now show 2.8.xxxx as the branch (devel)

Then back to updates and system updates , there i selected 2.6.0
Then i switched to update settings.
Now i was shown this

And could select the "Previous 2.6.0".

/Bingo

[NollipfSense]

@bingo600 I am not seeing the "Devel" branch to upgrade from 2.7 to 2.8 for my VM...even after rebooting twice.