Access from LAN1 to Access Point on LAN 2
-
Hi everyone,
I have a configuration with 4 LANs and 3 WANs, from the main LAN, which I call LAN1 for convenience (10.10.1.0/24), I can go anywhere, to any peripheral on the other LANs or WANs, except on a TP-Link EAP610 AX1800 which is located on LAN 2 (10.5.1.0/26).
When I try to log in on the gui, the request times out.
PFSENSE itself sees the device as if it were offline (which it won't be, it's on).
Obviously if I'm on LAN2 I can easily access it.
I tried to see if there was any particular configuration on the aforementioned access point, but nothing.
Has something similar ever happened to you? Is there a workaround to resolve this?Thank you
Regards,
David -
@orphen76 said in Access from LAN1 to Access Point on LAN 2:
from the main LAN, which I call LAN1 for convenience (10.10.1.0/24), I can go anywhere, to any peripheral on the other LANs or WANs, except on a TP-Link EAP610 AX1800 which is located on LAN 2 (10.5.1.0/26).
When I try to log in on the gui, the request times out.
Obviously if I'm on LAN2 I can easily access it.I guess, the device is simply blocking access from outside of it's own subnet.
If it has no setting to allow this you can masquerade traffic coming from the main LAN and destined to it by an outbound NAT rule.
-
@orphen76 wifi router that you are using as AP quite often do not allow setting a gateway, so its not possible to talk to them from another network.
Also many of them might not allow access from a non local IP to the gui, some of them have settings to allow for that.
Does your AP have gateway set to pfsense? But as mentioned by @viragomann doing a source nat so that the AP thinks your talking to it from pfsense IP in that network is a common work around either of those problems
-
The "Layer-3 Accessibility" option of the AP's Web server needs to be enabled.