DHCP configuration for zones (IPv4) is overriden.
-
When doing config immediately after install on a new system (Built to replace failed main system) was having to do "hand copy" of DHCP config info.
The pfSense system came into my LAN after this LAN had been running for decades so I have certain servers at certain specific addresses (long story).
"Primary Address Pool"
So I entered the begining address of the primary pool, 192.168.1.10 (through) 192.168.1.133 and then saved it.
It is now showing 192.168.1.10 thru 192.168.1.245
I didn't notice this until after I put in the second pool which is 192.168.1.201 thru 192.168.1.235.
At this point the system put out a warning...
I'm able to correct it. But I don't remember this behavior with the prior 2 releases. -- Annoying, not a show stopper.
-
@Wylbur Sorry, I missed putting in that this is a 2.7.2 fresh install, not an upgrade.
-
Hmm, do you mean you were setting that in the setup wizard?
