Netgate 2100 enable traffic between 2 vlan
-
Hi, I’m a begginer..
I followed the instructions to create a vlan on a netgate 2100.
I would like to reach from the LAN (10.10.1.0/16) the IPCAM on LAN4 (192.168.100.1/24).
Ping (from LAN to LAN4 and from LAN4 to LAN) respond only if I execute it from firewall.
I can’t open from LAN the webpage of ipcam
Could someone help me to undestand what I missing ?
These the configuration
Thanks
Andrea -
@acurti Your bottom two LAN firewall rules will never trigger because the allow to any rule is above them.
Does the camera have its gateway set to pfSense? Does it have a firewall that allows pings from other subnets?
I didn’t look closely at the port setup, no coffee. But can you put a computer on the VLAN and get to The internet, or ping back and forth?
-
@SteveITS
You're great!
IPCAM Gateway was wrong!
Now it works fine.
Thanks
Andrea -
Yes the firewall rules and VLAN setup look good. This seems likely to be a routing issue (no gateway on the camera) or a local firewall on the devices.
What does work?
-
@stephenw10
I've set a wrong gateway on ipcam.
Change it with the ip of netgate finally solved the problem
Thanks
Andrea
