NPt will not route any traffic
-
I have been trying to learn ipv6 for the last couple of days and I got to the point where I was able to get static routing mulitrouter ipv6 public routing servers and ipv6 only with nat64 and dns64. Its safe to say I am a little bit familiar with the basics of ipv6. My provider gives me what I believe to be a /56 with 200 something /64 subnets. The only problem with these subnets is that they are 6rd so they correspond to my ipv4 which is not static. I want to have publicly routable servers and clients with direct public ipv6 addresses, as ipv6 designed for. I went to NPt for this so that I can have a constant lan and easily change the WAN. I have started ever so incredibly hard at everything I can find on the internet and replicated what they did but with no results. I spent a lot of time seeing if chatGPT could help with no luck.
My setup goes as follows (simplified for basics)
WanV6 xxxx:xxxx:xxxx:xxyy::/56
default gateway for ipv6
has many working v6 /64 subnets working through itTest network dual stack: fd00:db8:d6a:2d03::/64
DHCP and RA setup how I normally do with same settings as working networksNPt: source subnet/CDIR fd00:db8:d6a:2d03::/64
Destination: xxxx:xxxx:xxxx:xxyy::/64
interface: I have tried both wanV6 and test network, one at a time and both at same time.All ping fail, and only local addresses within the scope of the "local" router and its Vlans, but proving that the network can handle V6. It almost seems like either NPt isn't listening how I think it is, or somehow the internal ipv6 network isn't getting to the NPt/the NPt isn't routing to the WAN
Any help much appreciated!
-
Anybody?