Netgate 6100 "dead" after reboot
-
I reboot the 6100 from my laptop via a web browser. When it rebooted, I couldn't reconnect and the 6100 seems to be "dead" from a software standpoint.
- I can connect to the console.
- At the end of the reboot, I get the messages in this image.
- If I do an LS command, I get nothing.
- I tried to do a factory reset by holding the reset button with a paperclip:
1st for the 5 seconds - nothing happens (light stays blue)
next for over a minute - nothing happens (light stays blue)
Help!
-
You simply rebooted? Not at upgrade?
If you have a config backup the fastest way back from there is going to be reinstalling. Open a ticket to get the recovery image: https://www.netgate.com/tac-support-request
Steve
-
Steve, thanks for the response! I did as suggested and reinstalled. Everything was going ok until I tried the same reboot from a browser (Diagnostics -> Reboot). Same problem as yesterday - back to needing to reinstall. Suggestions?
Thanks,
Craig -
Hmm, that's odd.
You installed 23.09.1 clean?
Is it running from eMMC or SSD? -
@cshinn try using a different usb stick. Yes I know it doesn’t make sense.
See this thread I unintentionally hijacked:
https://forum.netgate.com/topic/180432/certificate-verification-failed/13
