missing speed and duplex on wan interface
-
i am missing speed and duplex on wan interface what can i do to fix the issue?
-
Where are you seeing that? What does it show? What do you expect it to show?
Does the WAN interface fail to link? Fail to pass traffic?
Steve
-
@stephenw10 I am expecting it to show speed and duplex option like under LAN interface so i could change it to 2500Base-T.
WAN interface is linking and passing traffic . -
Where are you seeing that? The output of ifconfig?
What NIC type is that? How is it connected?
-
@stephenw10 I am looking under the interfaces in pfsense. Intel X550-T2 RJ45 WAN >modem LAN>switch
-
Ah so in Status > Interfaces?
Not show the link speed/duplex is quite common for N-base speeds. Is i actually linked at 2.5G? What do the linl LEDs at either end show?
What pfSense version are you running? What firmware version is on the NIC?
As far as I know the X550-T is one of the few NICs that has been shown to link at 2.5/5G so I'd expect it to work.