pfSense Plus Software Version 24.11 is here!
-
@Jax I believe you said you were running 24.03 so yes. If you have no intentions of going back to those previous versions, their snapshots should be safe to delete which will probably free a significant amount of space
-
@juanzelli Yes, running 24.03 .. but all that amounted to less than a meg, I think.
Now I'm wondering about /var/cache/pkg which is about 312 Mi -
The BE snaps show a lot less than they actually use on the disk.
-
Ha .. wait ... deleting those old boot envs freed up way much more space that I thought it would from the GUI interface .. (I'm in the shell direct as well) ...
So now that I have more space, I can just try to re-run the update?
-
@Jax You can run
df -h /to see what free space is available. I would think you'd have enough now to attempt the upgrade again. -
Updated and running, thanks, friends!
-
@mwatch finally got around to updating, was traveling and other stuff..
Have to say very clean update.. So far everything looks good. Only slight little anything was got warning about another upgrade process running when setting to 24.11. But like it said check back later, so did few minutes later and all good clicked confirm and few minutes later on 24.11
This was my sg-4860. I didn't even bother to uninstall any packages or anything. I did take my backup of config, and download latest copy of the new installer just in case.
I was kind of, kind of ;) thinking will if this goes wrong - forces me to move to ssd install vs emmc. I have one sitting on my shelf and ready to go.. But pfsense is so nicely snugggled into my rack - and don't feel like unhooking everything and taking it out, etc.. ;)
As always great job guys!
From notification emails I got it took this long
08:32:33 System is going to be upgraded. Rebooting in 10 seconds
08:39:28 Bootup completeSo what like 7 minutes.
-
@johnpoz said in pfSense Plus Software Version 24.11 is here!:
Only slight little anything was got warning about another upgrade process running when setting to 24.11
Yeah, got that too ... what was that?
-
If you go to the upgrade page from the dashboard the upgrade check may still be running. Or when you switch branches the upgrade check against the previous branch may be running. You're more likely to see it on slower CPUs. It's actually not a new issue it's just reported more accurately now.
-
@delphin_007 : please see this thread if my patch /Work around helps you.
https://forum.netgate.com/topic/190987/squid-error-fatal-unknown-http_port-option-no_tlsv1/9?_=1735383414679
There is indeed an issue with Squid when acting as mitm. Some options are broken, hopes that someone Will Make a proper fix
