Racoon: ERROR: couldn't find configuration
-
why am i getting this in the ipsec log on a new 1.2.3 box? i have definately defined a config:
racoon: ERROR: couldn't find configuration.
thanks -
Did the config get written out in /var/etc ?
If not, that would be the problem… Now why that didn't happen, that's a whole other question. Might take some more investigation. I've never seen that happen on 1.2.x, but I have on 2.0 when the WAN wasn't up when racoon started. That didn't happen on 1.2.x though that I'm aware of. -
there is a default looking racoon.conf there but my tunnel config is not being written.
-
Is this a full install or nano? If it's nano, did you write out the image or did it come on a CF preinstalled?
-
this is full. i changed the remote site from hostname to ip and made sure the wan was up and it wrote the config to file now.
-
I had this problem a few times after upgrades:
http://forum.pfsense.org/index.php/topic,15878.msg94828.html#msg94828
during the last upgrade to 1.2.3 Release, it was fine, no problem.
If i remember, all i needed to do was go into my configuration and save it again.
