NAT with MultiWAN and VIP



  • Greetings,

    I need help to setup the following network as attached.

    Network Interfaces Configured on PFsense:
    WAN1 IP Address: 192.168.10.2
    WAN2 IP Address: 192.168.20.2
    LAN IP Address   : 172.16.17.200
    VIP1: 192.168.10.3
    VIP2: 192.168.20.3
    (Just to mention that in the actual network WAN1/WAN2/VIP1/VIP2 IP addresses are Public IP Address)

    VPN Router: 172.16.17.201

    We want to use Multiwan failover option.
    VIP1 to be used as default for Outgoing NAT for the VPN router.
    Failover should be through VIP2.

    If it is a matter of outgoing traffic through one link, there is no problem.
    But we want a proper failover link.
    Please let me know how I can setup this link.

    Rgds,
    Sunny




  • What exactly is your question?
    Did you try to set that up?
    Read the docs or here in the forum in one of the hundreds of threads about this.
    Or buy the book where you'll be guided step-by-step.



  • My requirement is to provide connectivity to one of my clients for VPN connection between his office and remote branch office.

    The primary connectivity is through fibre with backup through a Vsat connection.
    We want the backup to be seamless such that the vpn tunnel should be able to connect through the vsat.

    There are 2 WAN connections on the Pfsense and am thinking of using VIP's of each connection(fibre and Vsat) and map it to one of the LAN IP's.


Locked