ALIX 2D3, PfSense 1.23: only vr0 recognized
-
I've installed PfSense 1.23 on ALIX 2D3 http://www.pcengines.ch/alix2d3.htm and when it boots; it can only find vr0. The other NICs aren't detected. I'm using the 4g image on a 4g card. The bios of the ALIX device is the latest: 99h. A year earlier, all worked fine with the then current version of PfSense.
Thoughts???
~Mark
-
That may be a hardware issue.
So it wasn't used at all for a year? was there a problem when it was taken out of service?
I have many ALIX 2D3 boxes in the field and they all work fine with all three NICs.
You could try to image a card with 1.2.2 to see if there is any change.
-
It worked fine when last I used it, but I did try a number of different open source solutions. I might have zapped it one of the many times I removed or reinserted the memory card. At any rate I'll give your suggestion a try. Thanks, Mark
-
I currently have two ALIX 2D3 running 1.2.3 Released with no problems. I would try reflashing with 1.2.3 and if the problems still persists, save the aluminum case and throw the motherboard in the trash. BTW, have you tried another power supply?
Roy…
