Nat Problem … Interface adress ?
-
Another thing you could try is using RFC 1483 Bridge mode instead of Bridged Mode Only. The RFC mode allows the WAG54G to make the PPP connection and validate your username and password. After that is complete it will pass the public IP from the WAG54G to the pfSense box.
-
Ok … im @ work now ... but ill try that way ...
Thank you for your help ;D
-
;( it dont work :| in the bridge mode that you said we still have to make the autentification on the pfsense machine…
but it still dont work ...
how do i have to configure the wag54g ?
-
Im thinking … why in ppoe mode when i´m creating a NAT rule it apears (ext: ) and on dhcp it apears (ext: WanIp) ? it´s normal!
-
Yes, it's normal. All my portforwards at pppoe work and do show "ext:" too. It's only a cosmetic thing not showing an IP there.
-
there is an option on the wag54 "nat = enabled" it´s correct?
i dont know what to do … if I was on dhcp ... I´ll configure the DMZ ip on the router to the ip of the pfsense ... but ... on ppoe ... the wan dont have a Valid Lan IP ...
Tell me what are the defaults rules on the Firewall - Rules options to work...
???
thank you all ...
-
This really is a configuration thing of the WAG54 and I don't know it. Maybe a really "dumb" pppoe modem with no features would serve you best.
-
the problem it´s that i have a netgear adsl modem … but ... it only have ppoe and ppoa and not bridge...
and i´ve tried to put this modem on ppoe and the pfsense in dhcp and configurated the DMZ ip of the netgear to the pfsense ... and the same problem ;(
-
good news …
i´ve searched and ... i´ve founded a way to put the netgear on modem modem... and it still dont work ;(
i´ve updated the pfsense ...
still dont work ...
witch are the firewall rules ?
-
Ufff!! :)
i´ve found the problem :)
if i have the captive portal active … the nat rules and upnp dont work ... What do i have to do ?
Sorry guys .. and thank you :)