Ntop not working with 1.0.1



  • any body have the problem of not being able to run ntop on 1.0.1 or it's just me, i have this problem on 3 pfsense boxes.



  • how mutch memorie do you have on these pc's ???

    with more then 512 mb memorie ntop must work



  • Ntop is working, the issue more than likely is that you are using the https protocol and a non standard port for your webgui.

    To access ntop, change your protocol and port for the webgui back to http port 80.

    I have found the bug that is causing ntop not to work under https, I will have a fix soon.

    Also, make sure you have a rule to allow tcp port 3000 traffic destined to the LAN interface IP.



  • thanks, ill wait for the fix,  by the way it was working fine on pfsense 1, i have 1 gig memory, not using https, and how to change the web gui port?



  • @hadi57:

    thanks, ill wait for the fix,  by the way it was working fine on pfsense 1, i have 1 gig memory, not using https, and how to change the web gui port?

    You can change the webgui port under System>General setup. Make sure that you configure the settings for ntop. Choose a admin password for it as well as select at least 1 interface which includes your WAN if.

    If you're not using a custom port it should be working. Works for me. Anyone else having troubles?



  • well i don't know what i am doing wrong, i made the same setup as with my version 1 servers.  now all the servers that were updated to 1.0.1 ended up with ntop not working. while version servers of version pfsense are all working.



  • The fix has been committed. The next snapshot should have the fix implemented. Only other thing is if you have removed the LAN allow all rule make sure you allow port 3000 to the LAN interface IP.



  • i went to status> services, I found that ntop is not running, i tryed to started, but it wouldnt, so the problem was it is not starting at the 1st place, and still cant figure out why, any clues of what ive done wrong, since i copy the same configure from v1 and restore it to 1.0.1, by the way, my firewall rule is: allow all protocols and any port.

    thank u for your help



  • @hadi57:

    i went to status> services, I found that ntop is not stoping i tryed to started, but it wouldnt, so the problem was it is not starting at the 1st place, and still cant figure out why, any clues of what ive done wrong, since i copy the same configure from v1 and restore it to 1.0.1, by the way, my firewall rule is: allow all protocols and any port.

    thank u for your help

    Not sure. Might try reinstalling pfsense without importing your config to see if that has anything to do with it.



  • Not sure if this helps, but I had a similar issue that was caused by special characters in the ntop admin password.
      I have verified that the following special characters do not work: &)=%#!?}]
      These special characters do work: (^$@~<>{[
    Those are the only characters I had the time to test.


Locked