How to setup static arp entries ?

[aspineux]

I don't find  anywhere in the GUI to setup a static ARP entry !

I would like to make the same as

arp -s X.X.X.X Y:Y:Y:Y:Y:Y

does in the shell inteface

Regards

[jimp]

They aren't added by default unless you check the box under Services > DHCP Server for static ARP, and then they are pulled from the list of systems there.

However, there was a bug on 1.2.x and static arp entries were not properly set on reboot. It should work on 2.0 though, but there is still no easy way to have just a single static arp entry without going to static arp only.

You could always install the shellcmd package and put a shellcmd in that runs the command you want, then it would happen at bootup.

[aspineux]

@jimp:

You could always install the shellcmd package and put a shellcmd in that runs the command you want, then it would happen at bootup.

Not "easy", but the answer I was looking fore.

Thanks