Problem with Traffic Shaping Wizard on 2.0

[jimmyche]

Hello I am looking for some advice on the Traffic Shaping Wizard,

I've picked the "Single Lan multi Wan" wizard for my traffic shaping, I was then asked to enter the number of WAN connection.
I typed in 1 and I got the following message and I am not allow to proceed any further.

"You have less interfaces than number of connections!"

My Pfsense(2.0-BETA5 (i386) built on Sun Feb 6 05:09:46 EST 2011) is now running  fine on a EEEPC with the onbroad network adapter and an usb network adapter.
On the Interfaces tab, There's a LAN and WAN.
For some old reasons, there are 5 tabsunder the Firewall> rules Tab: Floating, lan, wan, LAN and WAN. Not sure if this contributes to the problem.

I have spent 3 hours myself trying to figure this out with no luck.
It's appreciated if anyone may provide me with some pointers.

Regards,

[jimp]

Use the single WAN multi LAN wizard, and enter 1 for the number of LANs. That works.

[jimmyche]

@jimp:

Use the single WAN multi LAN wizard, and enter 1 for the number of LANs. That works.

Thanks for the advise, just tried and still no luck.

"You do not have 1 of local interfaces!"