Help with DMZ not connecting out



  • Hi All,

    I was not sure where to post this.

    I have set up a web server on a DMZ interface per the m0n0wall instructions @ http://doc.m0n0.ch/handbook-single/#id11644437 using 1:1 NAT.  I am able to reach the web server from any host through the LAN or WAN interfaces; however, when I try to make a connection out from the web server, I am not able to connect to any other host including the DMZ gateway IP.  I have tested this with an additional PC plugged into the DMZ interface and it also is not able to connect to any other hosts.

    Is there something missing from my conifg?  A route?  Outbound NAT rule?

    I'm not sure where to proceed so any nudge would be appreciated.

    -Eric



  • Doh!  OK, I think I may have found a problem.

    It appears that I had set my default allow all Non-LAN traffic to PASS rule too restrictive with just TCP as the protocol instead of any.

    Appears to be happily pinging and resolving hosts now.


Log in to reply