Pfsense + SDSL + ADSL problem [SOLVED]
-
Hello,
Bonjour,
I have a problem with a pfsense box with an ADSL 18Mbits and a SDSL 1Mbits in load balancer mode : the ADSL link is limited to 1Mbit
I've tried a lot of things :
- Other modems : Business Livebox 100, Linksys AM200, Netgear DP111 (?), in half-bridge mode because pfsense can't handle PPPoA, link limited to 1Mbit
- Others modems : In routed mode, same problem, link limited to 1Mbit
- Modems directly on the local network, no limitation, 19Mbits max
- New pfsense box, fresh install (with modems) : same problem, link limited to 1Mbit max
Does anyone know what is the cause ? I will lose my customer if this continue, we have this problem since January
Kinder
-
I don't know how load balancer is supposed to work but it seems to me that if you say you want to balance the traffic across two links of unequal capacity you will max out at about twice the capacity of the slowest link. (If you have both links using their full capacity the load is not "balanced".)
Perhaps if you explained how you expect the two links to behave someone with a bit more knowledge might be able to suggest how you should configure your pfSense to achieve the result you desire.
-
It is supposed to work like that :
I have a pfsense box with 2 links in fail-over mode (not in load balancing mode like I said) :
- one ADSL link, only for Internet
- one SDSL link with a VPN tunnel for production use (mail, TSE, AD sync)
-
Hello,
I found the solution :
It was the traffic shaper. It was set to 1024 Kb/s, because the ADSL link wasn't available when the pfsense box was installed. So only the SDSL link was configured on the pfsense box.
A modification of the traffic shaper (19Mb/s) and the ADSL link is no more limited.
Thanks
Kinder
-
Hi ,
I am new to pfSense and I am having some trouble setting up my box.
I have 2 link ADSL 1.0 Mbps with dynamic IP and SDSL 1.5 Mbps with static IP. Plan to setup in load balancing mode so that I can get total speed of 2.0 / 2.5 Mbps . The ADSL link is successfully setup and can pass traffic. The problem is I can't get the SDSL to work.
If I connect my PC directly to the SDSL modem router I can access Internet with full speed (1.5 Mbps upload/download) but when I connect it to the WAN 2 port it cannot pass any traffic. try to ping from WAN to to Internet also not success. Have tried google but still cannot get it to work
Any idea on how to setup in this situation or maybe Kinder could u please show me how to setup since I think your setup and mine are more or less similar? Any help is appreciated
TQ