Multi WAN & Multi VLAN
-
Do you have VLANs on your network other than Mobile1, Hotspot and CO? You have different subnets on the other side of your switch?
Adding a gateway to Mobile1 causes pfSense to treat it differently. If you have not changed anything it will be NATing traffic on that interface for example which you almost certainly don't want.
Steve
-
Do you have VLANs on your network other than Mobile1, Hotspot? Yes
You have different subnets on the other side of your switch? Yes, we have many vlan, but only some vlan that we route to pfsense.
I want mobile can connect to others vlan and also have different route to internet -
Ok, your network is more complex than I realised.
However you still don't want to have a gateway on Mobile1. Instead add static routes to your other subnets.
I'm not sure how that might work with clients on the mobile1 subnet though. Traffic would have to route in and out of the same pfSense interface and I'm not sure that's possible. :-\Steve
-
Still not working… I think I have to go to alternative, install another pfsense
-
When creating a static route the Network should not be in the same subnet as the Gateway, ie 10.10.10.0/24 and 10.10.10.1 in your case. In a static route the Gateway is an IP address that is directly reachable from a local network, while the Network is one that is not directly reachable, hence the use of a route and gateway.
What type of interface is WAN2 (dhcp, static, pppoe, et)? What is WAN2's IP address?
-
Hi,
IP Address WAN2 (Static) 10.10.10.123 /24
Gateway 10.10.10.1 /24I have tried to remove the static route as advice by Steve
Regards
Gunawan -
I think a diagram of your network could help to clear things up here.
Steve
-
When I setup WAN2, should I set the load balancer?
I have read several
