1:1 NAT on new setup not working
-
My pfsense died a few day ago, and I had to configure a new setup. I have a /29 block of static IP's from my ISP. I use one of these on my firewall WAN, and need to nat one address into the network. I have this set up exactly as I had it before(I think), but it does not work. I attached pics of the appropriate screens. I get no traffic to pass, and no logging on any firewall rules attached to the nat address. need some help. thanks
-
Looks right.
Try changing your virtual IP to alias…
Other should be fine but the change may jar things...
http://doc.pfsense.org/index.php?title=What_are_Virtual_IP_Addresses%3F
-
You most likely cannot use Other type VIPs on your WAN subnet, you'll have to have L2 responses, so PARP, CARP or IP Alias must be used.
-
@cmb:
You most likely cannot use Other type VIPs on your WAN subnet, you'll have to have L2 responses, so PARP, CARP or IP Alias must be used.
Yea- what he said! ;D
Thanks Chris!
(bows head)
-
Looks right.
Try changing your virtual IP to alias…
Other should be fine but the change may jar things...
http://doc.pfsense.org/index.php?title=What_are_Virtual_IP_Addresses%3F
this did it. Thanks.