4. Rename Gateways on pfSense 2.0.1 not allowed - in 2.0 it was

Rename Gateways on pfSense 2.0.1 not allowed - in 2.0 it was

  • N

    Hi,

    in the past, when I used pfsense 2.0 I created to WAN interfaces called WAN1 and WAN2. This name was transfered to the SYSTEM -> Routing -> Gateways.

    Now I am using pfsense 2.0.1 and I added a third WAN interfaces but no renaming is allowed. Take a look at the screenshots.

    Thanks!





    0
  • C

    that’s never been permitted. can either very carefully manually edit the config with viconfig and make sure you don’t orphan any references, or backup the config and do the same edit and restore it.

    0
  • N

    @cmb:

    that’s never been permitted. can either very carefully manually edit the config with viconfig and make sure you don’t orphan any references, or backup the config and do the same edit and restore it.

    Hi cmb,

    thanks for feedback. I found out that if I rename the interface under INTERFACES from eg. OPT2 to WAN3 then the gateway in ROUTING is called WAN3. This is working if the interface is in DHCP or Static mode.
    When it is in PPPoE the name is “OPT2_GW”.

    0
Locked
 

© Copyright 2002 - 2018 Rubicon Communications, LLC | Privacy Policy