Failover working…except port 80?



  • I setup a failover group that has WAN1 on tier 1 and OPT1 on WAN2. I changed the firewall rules to use the failover GW. When i tested by disconnecting WAN1, I cannot surf to any website. However, my email is coming in. This tells me it is working partially. Where else can I check. I can ping the DNS IP address from OPT1 while WAN1 is disconnected but can't do any tracert



  • Do you have squid enabled? if so you need to make a few more changes

    Also ensure your DNS is set to work on both WAN's



  • I actually figured out it was a problem with NAT. Thanks


Log in to reply