Multiple Network Passing Tunnel

[hsiang]

below are my configuration

192.168.1.0/24 –-------                                                  LAN                WAN                    WAN                  LAN
10.10.10.0/24 ---------- switch with routing interface -------------PFSense A-------- Internet---------PFSense B----------199.1.1.0/24
172.32.0.0/15 ----------                                          192.168.1.1

All the 3 network behind PFSense A will need to access to Network 199.1.1.0/24 behind PFSense B using IPSEC Tunnel.

1. To Configure IPSec Tunnel in PFSense A, under local subnet, what is the type i should choose? If for type Network, how i can add in multiple network entries?

2. To Configure IPSec Tunnel in PFSense B, under remote subnet, what entry i should put in since I have total 3 networks need to access?

[hoba]

Please search the forum, this has been answered in detail already several times.

[hsiang]

thanks Hoba.

I had searched the forum, the advice is having parallel tunnel with unique identifier.

1. In the IPSec Tunnel setting, in phase 1, i choose identifier as My IP address and in pre-shared secret, i put in the entry identifier - IP of the box at remote site and the shared secret. In order to have unique identifier as mention, i will not use My IP address? Sorry I am a bit blur in this Identifier setting.

2. If the tunnel i pair up with a checkpoint firewall, so at the checkpoint side i will need to create multiple tunnel also? In check point i did not see any setting for identified? how i can make the tunnel unique?