Few PBlocker problems with setup



  • Hello all,
    I just installed pfblocker for a second time on my system and had the same results.
    Background:
    Two Pfsense 2.01 FW with Muti WAN. (multiLan)
    On installation, it would appear everything is ok, once I start selecting block rules, the system will start to give errors like, can load rules. (Note: Before I even installed PFBlocker I adjusted Maximum number of table entries for systems such as aliases, sshlockout, snort, etc, combined. To 999999999)
    I had to rebuild the boxes and restore a working config prior to pfblocker installation. (Both times)
    What was happening:

    1. Second Carp FW would respond to ping, but I could not get to web gui.
    2. All traffic out was blocked
    3. First FW gui was a bit slow to respond
    4. PFBlocker Rules would appear twice on my WAN Interfaces (both fw)

    Specs for both boxes:
    Version 2.0.1-RELEASE (i386)
    built on Mon Dec 12 17:53:52 EST 2011
    FreeBSD 8.1-RELEASE-p6

    Platform pfSense CPU Type Intel(R) Core(TM)2 Quad CPU Q9400 @ 2.66GHz
    4GB Ram
    Since this happened on two clean installs, I am not sure what I am doing wrong.
    Any help would be great.
    Thanks in advance



  • ok, same thing just happened again.
    Anyone else having this problem.
    thx


Locked