Power saving?



  • I'm looking at trying to enable powerd on my x86 based pfSense box, and wondered if it would be possible to have cpufreq added (as a module I suspect) to the pfSense kernel, along with the powerd binary.  A quick test on a VMWare image suggests that, with ACPI enabled, this works (cpufreq.ko copied from the developer ISO and powerd copied from another FreeBSD 6.2 host).

    I'm having a look at this myself, but given that I've never done any pfSense development before, I thought it would be quicker to put in a plea here :)

    The reason I'm wanting this is that I've got a passively cooled 1.2 GHz box (FX5620) that spends most of it's time idle (<15%), but hot.  I'd rather like to reduce the processor speed, when it is idle, so that it runs a bit cooler.

    TIA



  • I have included both powerd and cpufreq module going forward.  It will appear in snapshots later today.

    I would suggest a /usr/local/etc.rc/powerd.sh script as follows:

    kldload cpufreq
    powerd &

    Be sure to chmod a+rx /usr/local/etc/rc.d/powerd.sh after creating.  Also, the .sh is absolutely needed for pfSense startup scripts to source the file correctly on bootup.



  • <blink>Darn that was quick - thanks!</blink>



  • And, typically, while it works in the VM it turns out that the FX5620 isn't supported by FreeBSD's implementation of ACPI:

    ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
        ACPI-0159: *** Error: AcpiLoadTables: Could not get RSDP, AE_NO_ACPI_TABLES
        ACPI-0213: *** Error: AcpiLoadTables: Could not load tables: AE_NO_ACPI_TABLES
    ACPI: table load failed: AE_NO_ACPI_TABLES

    Ah well, it was worth a go - I guess it'll just have to stay toasty :)


Log in to reply