Error mapping mbuf into TX chain!
preatorian_1 last edited by
After installing Pfsense 1.0.1 on the brand new PowerEdge 1950 - this issue came up:
_ if I try to connect to the WEB interface or conduct any traffic with LAN nic - system goes crazzy:
bce0: /usr/src/sys/dev/bce/if_bce.c(4644): Error mapping mbuf into TX chain !
- all I can do is power down - restart - and the same error comes up again !
Any ideas here ? - the box has 3 NICs (2 x (BCE0:, BCE1:) Gbit on board and 1Gbit (BGE0:) on a pci card)
Best regards !
- hope this gets resolved soon -
sullrich last edited by
Try upgrading to http://snapshots.pfsense.com/FreeBSD6/RELENG_1_2/