Bandwidth limit to an IP by IP range instead of (Traffic type, service, UDP etc)

[gsoul5005]

Hi,

I would like to know if its possible to set a speed limit to a user/IP by/to a particular IP/IP range.

I know its possible by traffic type, service, port, etc.

What if I want to exclude an IP range (or set a different speed limit) from bandwidth management to a particular user/Ip.

Any clue or help will be appreciated. Any other softwares?

Thank you.

[stephenw10]

I can't see why not.
Set up your limiters as you would normally. Create your firewall rules that send traffic via the limiters. Simply configure the firewall rules appropriately, 'has destination: IP range you want limited'.

http://doc.pfsense.org/index.php/Traffic_Shaping_Guide#Limiter

Steve

[kalu]

hi stephenw10
if i setup limitters 256kpbs up / 256kpbs down and assigned this limiter to multiple ip addresses would it divide the 256 kbps among all the ip addresses or it will assing 256kbps /up/down to each individual ip's
Thanks
kalu

[stephenw10]

Hmm, I'm not sure I haven't used limiters for while.
Probably easiest to test it and see. I think JimP mentioned this relatively recently though, could be worth a search.

Steve

[jasonlitka]

@kalu:

hi stephenw10
if i setup limitters 256kpbs up / 256kpbs down and assigned this limiter to multiple ip addresses would it divide the 256 kbps among all the ip addresses or it will assing 256kbps /up/down to each individual ip's
Thanks
kalu

Depends on how you make the limiters.

[kalu]

Thankyou jason litka
could you please elaborate your answer.
what do you mean by, depends how you make the limiters.
kalu

[gsoul5005]

Thank you very much, You words were very helpful. @ stephenw10

[jasonlitka]

@kalu:

Thankyou jason litka
could you please elaborate your answer.
what do you mean by, depends how you make the limiters.
kalu

You make two limiters, one for inbound and one for outbound.  When you create them, use Source & Destination masks respectively to give each user his/her own pipe.  If you want everyone lumped into a single pipe then use None & None.

[stephenw10]

Here is JimP's post I referred to:
http://forum.pfsense.org/index.php/topic,57351.msg306206.html#msg306206
It just confirms what Jason said above.  :)

Steve

[kalu]

Now i got it friends :)
Many thanks stephenw10 and jason litka
kalu