PfSense IPSEC VPN on Second LAN Interface
-
Hello everyone, thank you in advance for reading this post. I have a issue with a supplier that requires a IPSEC tunnel with a local subnet different from my LAN as they have used it for another connection. I use to put a VPN router in front of the WAN and have the VPN router do the tunnel, then it would communicate with the pfSense behind the router. I am sure pfSense should be able to do this without extra piece of equipment. I added another network card, and set the IP and subnet to the vendor specified, and non-overlapping with vendor. Did not bridge the connection, and did not put in a gateway in the settings. I then create the IPSEC tunnel with the new LAN subnet and it fails to connect. It will only connect if the LAN interface subnet is used. Is there a way around this? The vendor cannot see my LAN subnet and should only see the secondary LAN subnet. I tried bridging and adding the gateway and it does not connect. Only connects if I use the LAN subnet. Thank you.
-
I have solved my dilemma, just upgraded to 2.02. Thanks everyone for reading.