IPv6 only for DMZ0 and DMZ1

pthauer

Hi everybody
new here in the forum.
I need to setup a test environment without real Internet access. Just a faked virtual network with an public IPv4. But the 2 DMZs must have IPv4 and IPv6. And Routing in between of course. also LAN has just IPv4. All Networks are virtual ones running in Virtualbox.

any help welcome
peter

doktornotor

http://doc.pfsense.org/index.php/Configure_Multiple_IPv6_Subnets

The-Saint

Ok with this manual I got the LAN configuration working but if I make the steps with the DMZ interface I got the error message that I can use the Client IPv6 Address just for one device.
And also I can't connect anymore over OpenVPN to my computers at home if I make a rollback to the start configuration everything works fine.

Someone has a idea how I get IPv6 on DMZ working and connection for OpenVPN?

Kind regards
Simon

doktornotor

@The-Saint:

I make the steps with the DMZ interface I got the error message that I can use the Client IPv6 Address just for one device.

Uhm… you misunderstood the howto, try again. Nowhere it says to use the same (client) IP multiple times.

The-Saint

IPV6LAN
Use the HE client IPv6 address as the interface IPv6 address

IPV6DMZ
You’re going to type your HE client IPv6 address into the IPv6 address box.

And if not what kind of IPv6 adrdress I should use :) instead of the one in the manual?

Kind regards
Simon