Routing /30 Subnet from Teksavvy
-
I can't figure out why my setup isn't working… any suggestions would be much appreciated.
I have a /30 subnet assigned to me by my ISP, Teksavvy. They assigned me x.x.x.88/30 (x.x.x.89 and x.x.x.90 usable). Teksavvy assigns a static IP (separate from the /30 subnet) to the PPPoE connection (on WAN interface) and routes the public subnet through this static IP.
I assign x.x.x.89 to my LAN interface. No rules on Advanced Outbound NAT for LAN subnet.
I assign x.x.x.90 to the host connected to the LAN interface via DHCP (gets x.x.x.89 as gateway and dns, and 255.255.255.252 as mask).
I add a firewall rule on the LAN interface to allow all from LAN subnet to any (wide open for testing purposes).
I add a firewall rule on the WAN interface to allow all from any to the LAN subnet (again, wide open for testing).
Problem: my connected host (x.x.x.90) has no internet access, and any services running on the machine are not accessible from the internet at x.x.x.90.
What have I done wrong?
-
Update: Upgrading to 2.1-RC1 (July 30 build) immediately fixed the problem. My /30 subnet is now routed properly.
I was tired of starting at firewall and NAT rules looking for a typo, so I thought I'd try upgrading. As soon as the system rebooted from the upgrade, the /30 started routing. I was on 2.0.3 (RELEASE) before the upgrade.
Not sure if it was the upgrade or reboot that fixed the problem, but not one line of configuration changed.
-
I'm a teksavvy user also but I have their IPv6 service turned up also. Let me know if you need any screencaps of my config if you go down that road.