Help with Outbound nat



  • hi just wondering what Outbound nat does and how i should conf it ? i have 4 interfaces Green Orange Red And Wlan



  • it does what it says what it does:

    If advanced outbound NAT is enabled, no outbound NAT rules will be automatically generated any longer. Instead, only the mappings you specify below will be used. With advanced outbound NAT disabled, a mapping is automatically created for each interface's subnet (except WAN). If you use target addresses other than the WAN interface's IP address, then depending on the way your WAN connection is setup, you may also need a Virtual IP.

    You may enter your own mappings below.



  • do you now what it should lok like if i have 4 interfaces to ?



  • depends on how you want to NAT.
    what do you want to do?



  • i just wondering if this conf is right ? or if i have to do some thing else. i want to surf on the internet and play som games.

    ![Nat ot 1.JPG](/public/imported_attachments/1/Nat ot 1.JPG)
    ![Nat ot 1.JPG_thumb](/public/imported_attachments/1/Nat ot 1.JPG_thumb)



  • If 192.168.32.0/24 is your LAN-subnet from which you want to play games it is good that you have the static-port option active.

    I assume that 192.168.33.0/24 is your WLAN and 192.168.2.0/24 your DMZ.
    These rules look good to me.



  • ok thanks for the help


Log in to reply