Transparent Firewall and limiters



  • I am new to pfsense and am trying to make the following configuration work.

    Internet-provider–PF(bridged with limiters)--ClientFW(with IP from provider)--Internal network.

    I have version 2.1.1
    I added any any rules to both the LAN and WAN interfaces set NAT to manual removed rules set the link to 1.

    it was passing traffic till I added the limiters to the in/out then it would stop passing any traffic.

    Any and all suggestions would be greatly appreciated.


  • Rebel Alliance Developer Netgate

    That configuration requires you to assign the bridge interface and configure an IP address there rather than on a member interface.

    https://redmine.pfsense.org/issues/1634