PfSense not booting after install, waiting for F1
-
Board apu1c4, with 16GB SSD, Bios: April 5 2014
SSD: http://www.pcengines.ch/msata16a.htmF1 pfSense
F6 PXE
without pressing the F1 key it will not continue.
PS: If I press 'F1' it works fine.
I found somewhere the following:
/sbin/sysctl kern.geom.debugflags=16
gpart set -a active -i /dev/ad0s1a ad0
/usr/sbin/boot0cfg -s ad0s1a -v /dev/ad0
/sbin/sysctl kern.geom.debugflags=0but I get errors since my HD is ad4
gpart set -a active -i /dev/ad4s1a ad4 (gpart: Invalid value for 'i' argument)any ideas
-
What happens if you try a reinstall to that hardware.
-
never mind, just needed to wait for 20..30 seconds and it continued to boot.