Upgrade from 2.1 stuck - corrupt ad0 - otherwise unit works
mickrussom last edited by
I have a router with a 6 interfaces, serial, with a 4GB card.
I upgraded to 2.1 no issues.
However, no upgrades (2.1.1, .2, .3, .4) can be applied thereafter.
I am attaching a log of the attempt at an upgrade, within there is a dmi/smbios dump, an lspci, the upgrade log and the fdisk output.
The two main errors I see are:
gpart set -a active -i 2 ad0
gpart: table 'ad0' is corrupt: Operation not permitted
fdisk: invalid fdisk partition table found
This unit is remote and difficult to reach, I would like to try to fix it without going there.
The unit is a LANNER FW-7535 .
Looks like you already posted to the correct thread for this:
Locking this one out.