6 WAN / 1 LAN + Port Forwards

[arduino]

I have spent the last couple of hours trying to figure this out.

I have 6 WANS setup as a gateway group ( load balance ) and I can access everything internally but I cannot access anything from outside the network.

I tried to port forward the following:

WAN1>>PORT 443>>10.10.10.1
WAN2>>PORT 443>>10.10.10.2

I can see from a packet capture the traffic is coming in and then not being routed out the correct interface. I presume I can set this up using outbound NAT rules but I am unsure how.

Not sure if this is related information or not but all IP's are dynamic and use DynDns.
Modify message