ISO File and a Documation how to set up

[vikozo]

Hello
i would like to use pfSense for NAT a public IP to multiple private IP.

i would like to use
Multiple Domain
Multiple Subdomain
Multiple openVZ Container / KVM

at this time i have a running Proxmox.
First i Need to find a pfSense/openBSD Install ISO file, proxmox is not accepting the GZ file.

have a nice day
vinc

[KOM]

You have to uncompress the iso.gz file first.

[vikozo]

:-[ ok - will unzip it!
If I set up a kvm how much Disk and how much RAM would it need?
have a nice day
vinc

[KOM]

Minimum Hardware Requirements

[vikozo]

@KOM
thanks for your feedbacks and links,
i would like to use pfSense on a KVM with Proxmox. and NAT some openVZ Container with diff. Homepage and Subhomepage.
i have unpacked and installed the iso file, but it stop when booting with 100% cpu usage

have a nice day
vinc

[KOM]

If you are using 2.1.5, it is quite old and is lacking some virtualization support.  Perhaps you could try the upcoming 2.2 version which is currently at Release Candidate status.

http://snapshots.pfsense.org/

I'm a VMware/Virtualbox guy and have no experience with Proxmox, sorry.

[vikozo]

what should be used 32bit or 64bit?
and @kom if you use also virtualisation how large is your disk and how much RAM you use?

have a nice day
vinc

and yes it is pfSense-LiveCD-2.1.5-RELEASE-amd64-20140825-0744

[KOM]

what should be used 32bit or 64bit?

x64

how large is your disk and how much RAM you use?

2 vCPU, 2GB RAM, 50 GB disk

[vikozo]

@kom
thanks so far, it seems im to stupid to set up.
in the boot/setup prozess he ask for lan wan port and can't find them because they are virtuelle.
i would hope he just go plane trough and gives me a ip adress to access but nothing

:-\

[KOM]

That's because 2.1.x has limited support for virtual devices.  I did say that you should try the 2.2. Release Candidate which has much better virtual support.  Either that or configure your VM to use Intel E1000 driver.  Use Google to search for 'pfsense proxmox network|NIC| card|adapter'

[vikozo]

all done @kom

KVM Setup
OS: Linux 3.x
Bus: SCSI 0
Storage: local
Disk size GB 50
Format: qcow2
cache: no Cache
CPU: socket 1
Cores:1
Type: qemu64
memory: fixed size 2048MB
Network: NAT mode
model: Intel E1000

call up Installer

• Accept default settings
• Quick/Easy Install
• Standard Kernel
• reboot
  =============
  then it start asking about VLAN y/n
  and about WAN port and so one

and i use: pfSense-LiveCD-2.2-RC-amd64-20141211-0341.iso