2.2 Traffic Shaper not working over LAN bridging (BRIDGE0 interface)?
-
Hi Gurus,
Just happened to done a in-place upgrade from 2.1.5 to 2.2.
Everything is working except somehow the Traffic Shaper not working over LAN bridging (BRIDGE0 interface) , which has no activity monitored from status > queues. Traffic Shaper over WAN is still working as usual.
Basically my LAN bridging is configured as stated in https://forum.pfsense.org/index.php?topic=56298.0 .I already tried by rebuilding LAN bridging and even from reset to factory default but still no luck…. :'(
Any hints or is this a bug in 2.2?
Cheers,
Chris Lee -
If you put the shaper rules on the bridge you need to set the System > Advanced, Tunables tab values for filtering on the bridge, too.
-
Yes, the setting was inherited since 2.1.5 on "Change net.link.bridge.pfil_bridge = 1" & "Change net.link.bridge.pfil_member = 0."
I even tried reapplied these setting, but the sharper still no go…. -
Does any1 have the similar setup (just to confirm not my "Layer8" problem :P ) to correlate for a bug report @ https://redmine.pfsense.org/projects/pfsense ?
-
I have not yet debugged this yet, but I have seen the exact same issue after an upgrade from 2.1.5 to 2.2.
I'm sure there must be a tunable that takes care of it.
-
I couldn't figure it out :-\
Traffic is seen on the member interfaces instead of the bridge. Filed a bug report: https://redmine.pfsense.org/issues/4405
-
Just noticed the same thing. On my Alix box at home I have bridged 2 interfaces (1 to the LAN switch and the other to the WiFi AP) and assigned the resulting Bridge0 to the LAN interface. I used the traffic shaper wizard and looking at the Queue Status page, the LAN queues always show 0 packets activity, no matter what. On the WAN queues on the other hand, I see traffic going to the appropriate queue.
Edit:
For the record I also have the System > Advanced, Tunables set to filter on the bridge interface. -
This post is deleted! -
Does it work when you remove the limiter?
-
This post is deleted!