PfSense - Tunnel Broker Setup Error
-
I am trying to create tunnelbroker in pfsense.
I get ipv6 addresses on systems that are connected to pfsense . i can ping each other's ip.
But i Cant ping ipv6.google.com or any other ipv6 sites .I am getting the error
From maa03s04-in-x02.1e100.net icmp_seq=1 Destination unreachable: No routethese are my configurations .
Please help :(
-
-
Dok .. I Tried everything similar to that ..
BUt i m nott getting.. :(
-
"I get ipv6 addresses on systems that are connected to pfsense"
And what IPs are those? Are they in your /64 from HE?
This is a pretty straight forward setup.. What ipv6 did you put on your lan?
What does your ipv6 traceroute look like? to say ipv6.google.com
-
-
so your first hop is ipv6 address you setup on your lan.. but then it goes nowhere, did you setup a gateway on your lan interface for ipv6???
What is your ipv6 route table look like on pfsense? See the default is the IPv6 address of the tunnel connection from HE.. In your post it should be your 18:e71::1 you can see this in diag: routes
Why did you turn off monitoring btw? Do you have your tunnel setup as default? See pic 2
-
Looking at the 0.0ms RTT and Monitor "none" on HENETv6_TUNNELv6 GW… Are you absolutely sure you did NOT tick the "Disable Gateway Monitoring" instead of "Default Gateway"?
