Dhcp and webgui problem 2.2.2

ozlecz

device: APU1D4 with 16gb ssd
pfsense 2.2.2 full install
=installation successful
=enabled dhcp server on LAN (re2)

FINDINGS
=dhcp was properly working for sometime like an hour and suddenly notice cant do a WEBGUI….
=check if my pc was getting any IP and its not getting any
=put a static ip on PC and ping the lan ip, and yes it was able to
=do a webgui and shows 503
=isolate issues by using another PC and same thing happened
=reinstall pfsense 2.2.2 but same issue

TEMPORARY WORKAROUND
=install nanoBSD 2.2.1 and as of the moment it was working fine

NOTE: One of my friend having an APU as well had experience same 503 error but was resolved only by rebooting the unit. His was on 2.2.1 nano

What seems to be the problem here....pls help

thx

doktornotor

Did you install bandwidthd?

ozlecz

did not install any package yet….

ozlecz

hello
havent seen that same prob on nanobsd versio 2.2.1

TRIED installing full version of 2.2.1
=tested for 2 hours and was okay
=booted the following morning and dhcp not working
=statically put ip address on PC and start the webgui which gives again 503
=checked the console on bootup messages and found

fcgicli: Could not connect to server(/var/run/php-fpm.socket)
pfSense (pfSense) 2.2.1-RELEASE amd64 Fri Mar 13 08:16:49 CDT 2015
Bootup complete