Unplugging WAN only failover WAN and not LAN
dan_j last edited by
This is my first go with pfsense. I'm testing prior to putting it into productions.
I've bought and followed the PDF book to set up a pfsense HA with two servers.
When I cut the power on the primary server, the secondary takes over with no problem.
But if I pull out the WAN cable, the WAN fails over, but the LAN remains with the primary server.
The same applies if I only pull out the LAN cable.
Any ideas? I can't find much help on Google about this.
I'm using 2.2.3-RELEASE.