Problem on Traffic shaping !! please help

hunderri

Hello,

So far i have a 2 wan interfaces and LAN. On Lan interface i created a rule that all my VOIP phone will use WAN1 and Computers WAN2. Wan1 is giving problems on quality, calls dropping, busy, etc. What i did is that i configured traffic shaping on both WAN-s. but i dont know what rule i need to configure, because i don's see traffic on Status: Traffic shaper: Queues - qVOIP.

Any help will be very much appreciated !!

Thanks,

Harvy66

i created a rule that all my VOIP phone will use WAN1

i dont know what rule i need to configure

You could start off by showing the rule that is supposed to work.

Nullity

Either via SSH or web-browser, run pftop and see which queues are getting their packet counts increased.

KOM

If running via SSH, use:

pftop -v queue

hunderri

for the VOIP do i need to create rules on NAT? any tutorial on VOIP configuration it will be very helpful !!

thanks!!

KOM

Have you run the wizard and created a default VoIP queue by filling in the Voice over IP page of the wizard? For traffic-shaping you use the Floating rules tab. Add a rule that directs traffic from your VoIP phones into qVoIP with your preferred WAN as the gateway.