ATA Status error

[shehan31]

Dear all;
I have started to get an error as ATA status error. Please refer the attachment. Also I have started to get more errors.



[doktornotor]

Replace the failed hardware.

[shehan31]

hello doktornotor,

What hardware do you suspect and how can i find it.

[doktornotor]

Hmmm? Obviously bad cable/bad HDD/bad MB.

[Guest]

I have started to get an error as ATA status error. Please refer the attachment. Also I have started to get more errors.

What hardware and pfsense version you where trying here out together?

[shehan31]

@BlueKobold:

I have started to get an error as ATA status error. Please refer the attachment. Also I have started to get more errors.

What hardware and pfsense version you where trying here out together?

i did a SMART test and obtained these results.


[Guest]

What hardware and pfsense version you where trying here out together?

With the question above I really want to know the following:
Hardware:

• CPU, vendor, model, GHz, cores
• RAM, vendor, DDRx, MHz, ECC or not ECC
• Mainboard, vendor, model, model number
• HDD/SDD drive or SD/CF Card, GB, vendor, model

pfSense:
32 Bit or
64 Bit
version number 2.1.x or 2.2.x

[shehan31]

@BlueKobold:

What hardware and pfsense version you where trying here out together?

With the question above I really want to know the following:
Hardware:

• CPU, vendor, model, GHz, cores
        -    Dell power edge SC440
        -  Intel (R) Pentium (R) D Cpu
        - Clock speed : 2.8 GHz, Bus Speed : 800MHz
        -  Dual core

• RAM, vendor, DDRx, MHz, ECC or not ECC
        -  Vendor : Transcend
        - 1GB x 2 RAMs
          - DDR2
        - 667 MHz
        - ECC: Yes (ECC-Dimm)

• Mainboard, vendor, model, model number

-  Dell PowerEdge SC440
    - Model No: CN-0YH299-70821-6A1-509G

• HDD/SDD drive or SD/CF Card, GB, vendor, model
      - SATA
      - 500GB
      - Samsung
      -Model : HD502HJ

pfSense:
32 Bit or
64 Bit
version number 2.1.x or 2.2.x : ) 2.2.4-RELEASE (i386

I have been running this system for nearly 2 months with minimum errors especially kernel errors. "approaching the limit on PV entries, consider increasingeither the vm.pmap.shpgperproc or the vm.pmam.pv_entry_max tunable"therefore i increased the vm.pmap.shpgperproc in the loder.conf to 500 . This is the only error that i got.

[cmb]

@shehan31:

i did a SMART test and obtained these results.

Your hard drive's dead.

[Guest]

-Model : HD502HJ

The last picture you have been posted and in the second line from above!
And yes your Samsung HDD is dead or creeping down!