Setting up a new sg-2440 and port forwarding isn't working



  • I've setup several pfsenses in the past and I swear I've done everything right.

    Port forward page:
    WAN TCP/UDP * * WAN address 443 (HTTPS) 192.168.2.2 443 (HTTPS) OWA
    move selected rules before this rule edit rule
    delete add
    change WAN TCP/UDP * * WAN address 2016 192.168.2.5 3389 (MS RDP) RDP to TS SERVER
    move selected rules before this rule edit rule
    delete add
    change WAN TCP * * WAN address 2015 192.168.2.2 3389 (MS RDP) RDP for SERVER

    Rules page for WAN adapter:

    • RFC 1918 networks * * * * * Block private networks
      edit edit
      add
      block * Reserved/not assigned by IANA * * * * * * Block bogon networks
      move edit
      add
      icon IPv4 TCP/UDP * * 192.168.2.2 3389 (MS RDP) * none NAT RDP for SERVER
      move selected rules before this rule edit
      delete add
      icon IPv4 TCP/UDP * * 192.168.2.5 3389 (MS RDP) * none NAT RDP to TS SERVER
      move selected rules before this rule edit
      delete add
      icon IPv4 TCP/UDP * * 192.168.2.2 443 (HTTPS) * none NAT OWA
      move selected rules before this rule edit
      delete add
      icon IPv4 ICMP * * * * * none Allow pings

    Rules page for LAN adapter:

        • LAN Address 443
          80 * * Anti-Lockout Rule
          move edit
          add
          icon IPv4 * LAN net * * * * none Default allow LAN to any rule
          move selected rules before this rule edit
          delete add
          icon IPv6 * LAN net * * * * none Default allow LAN IPv6 to any rule

    I'm trying to forward RDP from port 2016 publicly to port 3389 default internally. Same with another PC and port 2015

    Anything else I could be missing? It goes dsl modem -> pfsense box ->switch -> computers. I'm trying to RDP in from one of my outside servers which I'm also rdp'd into. This was working on our previous router, but now it is not.



  • …......................................





Log in to reply