Problems with pfsense configuring 2 networks



  • Hi everyone, i have a problem, please can you help me.

    I have two offices:

    office 1: 192.168.10.0/24
    office 2: 192.168.11.0/24

    My pfsense is located in office 2 with ip 192.168.11.253 (WAN), 192.168.1.0/24 (LAN) the problem is that i can't acces to resources from office 1 to office 2, in the office 2 i have the pfsense with internet and dhcp with the clients, but i can't get access from office 1, the two offices have a datalink with the ISP, and the internet from office 2 is reached by office 1, without the pfsense i have total access to resources from office 1, please can you help me if i'm missing a route, NAT or something like that..

    Thanks a lot…



  • Do you have Block private networks and Block bogon networks disabled on WAN?



  • thanks… i disabled that option in WAN but i can't get access



  • Hi everyone, i have a problem, please can you help me.

    What kind of Internet connections do you have. With dynamic or static public IP addresses?
    Or do you own two DynDNS Internet accounts? How do you want contact the offices each to the other?

    I have two offices:
    office 1: 192.168.10.0/24
    office 2: 192.168.11.0/24

    This IP addresses are internal or private IP addresses and they wont be routable through the Internet!
    You need two DynDNS accounts or two static public IP addresses to built a VPN connection between the
    both offices and then you will be able to connect to the other sides resources and devices.

    My pfsense is located in office 2 with ip 192.168.11.253 (WAN),

    So there must be something in front of the pfSense firewall that is holding or the
    getting the public IP address. If you want to built a connection between them you
    will need to set up a VPN tunnel.



  • Hi thanks..

    @BlueKobold:

    Hi everyone, i have a problem, please can you help me.

    What kind of Internet connections do you have. With dynamic or static public IP addresses?
    Or do you own two DynDNS Internet accounts? How do you want contact the offices each to the other?

    My internet connection is in office 1, then i have internet in office 2 by a datalynk with the isp, when a client in office 2 go to the internet it goes by public ip of office 1

    I have two offices:
    office 1: 192.168.10.0/24
    office 2: 192.168.11.0/24

    This IP addresses are internal or private IP addresses and they wont be routable through the Internet!
    You need two DynDNS accounts or two static public IP addresses to built a VPN connection between the
    both offices and then you will be able to connect to the other sides resources and devices.

    These ip are private internal addreses and it communicates by datalynk, then i can access from one side to other side, but in office 2 i don't have control about internet, then i want to install the pfsense.

    My pfsense is located in office 2 with ip 192.168.11.253 (WAN),

    So there must be something in front of the pfSense firewall that is holding or the
    getting the public IP address. If you want to built a connection between them you
    will need to set up a VPN tunnel.