PPPoE with vlan
-
I am gonna see if opensense works
-
I would expect it to work with the em port. How exactly was it configured?
Did the ppp logs show any replies from the server?
-
@stephenw10 No it won't even connect like you can see in the logs (in the photo album)
-
What is the WAN actually connected to? Some DSL modem?
It's possible the modem is already doing the VLAN tagging and you shouldn't have it configured in pfSense?
-
@stephenw10 it's connected to the router i have from the ISP it's set to bridge mode and uses cable tv. I could try without the vlan tag in pfsense
-
Yup try that. It might still be tagging WAN side in bridge mode.
-
@stephenw10 ok, will do when I get home
-
@stephenw10 it's still the same
-
Maybe the ISP requires something else like a priority tag?
-
@stephenw10 well i don't know since they don't know anything else than i need to setup username, password and it over vlan 101
-
Hmm, I'd be looking for something more basic then. Like maybe the bridge port on the router isn't the one you think it is. Or something as simple as a bad cable.
I would definitely use em rather than ue though. No way to know if VLAN tagging is working as expected on a USB NIC. -
@stephenw10 just tried new cable from em0 to the bridged router and tried all the ports on the router the same
-
Hmm, well my next step after that would be to try to get a packet capture of what the WAN is actually sending. That would probably require a switch configured with a mirror port in-line though.
Steve
-
@stephenw10 i can try to see if i can do it, where would i need to set my switch then? With a cable directly from the bridged router to it?
-
Well I'd first just try a pcap on em0 in pfSense directly and see if you see any incoming packets there. And that the outgoig packets are tagged as expected.
The problem with that is that the capture is after any hardware packet processing so potentially may hide an issue. A pcap from a switch mirror port always shows what's actually on the wire but is more difficult to do. Once you have that though you can capture what other routers are doing when the connection is working as expected.Steve
-
@stephenw10 Sorry it has been so long. I just did an packet capture
https://imgur.com/a/MyPM4ln -
Right so only the broadcast traffic from pfSense, no replies from the server at all.
If you expand the layer 2 info there you should be able to see the VLAN tags on it. Assuming you moved the PPPoE config back to em0.101.
Steve
-
@stephenw10 yeah i think so, the data captured i think it was on em0.101 not sure though
-
Ah, then try capturing on em0 directly so you can see the VLAN tagged packets.
Capturing on the VLAN won't show that. And it also won't show any replies that aren't using that VLAN tag.
-
@stephenw10 i haven't been home for some days now but i could try, if i even remember how i did it at first
