Rogers pfSense configuration

[jasonreg]

@jknott - OK now I am confused. So I removed the configuration for the LAN interface and I added the same configuration to one of my VLANs (JasonOffice) and everything works. So why can I not set up the LAN?

WAN is set up per above recommended configuration as is the JasonOffice Network. However, when I try to add this same configuration to the LAN or one of the other VLANs, I cannot track the WAN - says it is already assigned (which I guess it is). Have tried SLAAC and still get nothing.

On the Dashboard Interfaces, I see an IPV6 address under WAN and one under JasonOffice now. Gateways show WAN_DHCP Online and WAN_DHCP6 Offline, Packetloss though I do have an address.

[jasonreg]

Here are some screen captures.
WAN
login-to-view
login-to-view
VLAN
login-to-view
login-to-view

[mhillmann]

@jasonreg Probably this issue: [https://redmine.pfsense.org/issues/14072](link url) . It gives these symptoms.

[JKnott]

@mhillmann Do you have unique prefix IDs for each interface?

[jasonreg]

@jknott - Hi - if this was for me I would say likely not. I think there are a couple of steps I am just plain missing such as when/where would I do this?

[JKnott]

@jasonreg

With Rogers, you get 256 /64s. When you set up an interface, you have to provide a unique prefix ID. Your choices are 0 - ff. For example, I use 0 for my main LAN and 3 for my guest WiFi.

[jasonreg]

@jknott - so have this figured out and all interfaces and networks are being assigned an IPV6 address and I am getting IPV6 addresses on devices on the various networks - so I suppose I could stop and be stratified.

However, I was trying to figure out why the Gateway was showing WAN_DHCP6 Gateway shows Red "Offline, Packetloss". I changed the Monitor IP box to Rogers IPV6 DNS and the Red "Offline" changed to Blue "Pending". I also tried Quad 9 IPV6 DNS and have the same thing. I did reboot the pfSense box. I have not rebooted the Rogers XB8 Modem if that matters.

Thoughts?

[JKnott]

@jasonreg

For the monitor address, I just did a traceroute to Google and used the first address that showed up. However, with just a single WAN connection, that monitor doesn't do much.

[jasonreg]

@jknott - so given that last statement, should I maybe just delete the widget from my dashboard? My internal OCD will make me want to see the gateway as "Online" if I keep it there. I guess if IPV6 is working - maybe I just let it be?

[JKnott]

@jasonreg
It's up to you. If you can get the monitor working fine, otherwise disable it and rely on IPv4.